Jupiter 2 LCD PANEL

Description

Replacement LCD screen for the ELEGOO Jupiter 2 resin 3D printer. The LCD is the part that masks the UV light layer by layer, so its condition decides the sharpness and the success rate of every print.

Why replace your LCD screen?

An LCD screen is a wear part: every print exposes it to UV light, and over time pixels can fail. Replace it if you notice:

• dead or stuck pixels, lines, dark spots or patches that show up on the models;
• layers that do not cure, or parts that fail in the same area of the plate again and again;
• a cracked or scratched screen, or a screen that no longer lights evenly.

Key features

• Made for the Jupiter 2 — the replacement screen of ELEGOO’s large-format 16K resin printer (302 × 162 × 300 mm build volume), so you get back the original fine-detail quality.
• Ready-to-fit module — supplied as shown in the photos: the screen mounted in its black frame, with its connector board attached.
• Protective packing — delivered in a box with foam protection, to reach you without damage.

Compatibility

For the ELEGOO Jupiter 2 only. It is not interchangeable with the Jupiter, Jupiter SE, Saturn or Mars series screens. If you are not sure of your model, contact us before ordering.

Good to know

• Power the printer off and unplug it before opening it; handle the screen by its frame and avoid touching the glass.
• After fitting, run a short test print to check the exposure on your resin.
• Do not wipe the screen with solvents; use only a soft, dry, lint-free cloth.